Publicidad
Idiomas disponibles
Idiomas disponibles
Mailbox Solution Components:
(1) Cast Stone Post
(1) Cast Stone Post Cap
Materials and Tools Required:
• Ready to mix concrete
• Shovel or post hole digger
• Hammer
• Caulk (Clear)
Step 1. Dig a hole 8"-12" in diameter approximately 24" - 36" deep.* Review USPS mailbox requirement from the
curb.**
Step 2. Determine the height of the 4" x 4" or 6" x 6" wooden post by adding the depth of the hole plus 50". Mark
wooden post accordingly and cut off excess material with a saw.
Step 3. Place the 4" x 4" or 6" x 6" wooden post in the hole or concrete forming tube and gently tap the top of the
post with a hammer to secure the post in the ground.
Step 4: Mix concrete to manufacturer's recommendations and pour evenly around the post to the top of the hole.
Use a level to make sure the post is straight and secure until concrete sets.
Step 5: Slide the cast stone mailbox post over the 4" x 4" or 6" x 6" wooden post. Position cast stone post flush to the
ground and flush to the middle of the wooden post facing the street.
Step 6: Attach mailbox support arm to bottom of support using mailbox leg screw and Allen Wrench. The curved leg
must be placed into the recess so the bottom of the leg with the hole is facing the side for mounting.
Step 7: Depending on mailbox size (not included), either standard or oversized, the mailbox
support platform should be positioned between 38" to 43" high** from the ground.
Center the mailbox support on the cast stone post and drill through the pre-drilled
holes on the mailbox support and through the cast stone column, and into the wooden
post using a 9/64 masonry bit. Secure with three #10 screws.
Step 8: Further secure the mailbox support arm by drilling another hole at the bottom through
the pre-drilled hole and through the cast stone column, and into the wooden post.
Secure with one #10 screw. Use manual screwdriver for final seating of screw.
Step 9: Apply clear caulk to top of the cast stone post and secure the mailbox cap.
Step 10: To install the mailbox onto the mailbox support platform, follow the mailbox
manufacturer's installation instructions.
IMPORTANT NOTES:
*Before digging, check for underground utilities. The North American One Call Referral Service at 1.888.258.0808 connects
you to a national directory of utility companies.
**The United States Postal Service requires mailboxes to be installed with the bottom of the box at a vertical height of
between 3-1/2 to 4 feet from the road surface and 6 to 8 inches from the front face of the curb to the mailbox door.
Questions? Contact your local Eye Level Dealer or Eye Level Customer Service at 888.782.1760, option 3.
Installation Instructions
Cast Stone Mailbox Post
• (1) Mailbox Support
• (4) 3" Zinc Plated #10 Flathead Wood Screws • (1) Allen Wrench
• One 8' 4"x 4" or 6" x 6" pressure treated wooden post
• Tape measure
• Level
• 8" or 12" Concrete Forming Tube (optional)
2
• (1) Mailbox Leg Screw
• Drill
• Masonry drill bit 9/64
• Saw
• Phillips screw driver
English
Mailbox Support
ELCMBPS 02-12
Publicidad
