Toro 59165 Instrucciones De Instalación

Bagger Kit, 2008 and After Super Recycler
Mower
Model No. 59165
The grass bag is fully assembled and ready to use.
Bagging the Clippings
Use the grass bag when you want to collect grass and
leaf clippings from the lawn.
A worn grass bag could allow debris to be
thrown and result in serious personal injury or
death to the operator or bystanders.
Check the grass bag frequently. If it is
damaged, install a new Toro replacement bag.
If the side discharge chute is on the mower, remove it
and lock the side discharge door (refer to Removing the
Side Discharge Chute) before bagging the clippings.
The blade is sharp; contacting the blade can
result in serious personal injury.
Stop the engine and wait for all moving parts to
stop before leaving the operating position.
Installing the Grass Bag
1. Route the starter rope around the lower rope guide
(Figure 1).
© 2008—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
1. Lower rope guide
Note: The lower rope guide releases the starter rope
when you pull the recoil start handle.
2. Raise and hold up the discharge deflector (Figure 2).
1. Discharge deflector
3. Pull out the rear discharge plug (Figure 2).
4. Hang the upper front edge of the bag on the notches
(Figure 3).
Register at www.Toro.com.
Form No. 3359-759 Rev A
® Lawn
Installation Instructions
Figure 1
Figure 2
2. Rear discharge plug
Original Instructions (EN)
Printed in the USA
All Rights Reserved