Garland XTRIM 700 PE Manual De Instrucciones página 32

English
6.2.4. CHANGE OF THE NYLON BUMP HEAD
Dismounting
Loosen the bump head knob until it separates from
the transmission. Remove the empty bump head and
take away any remaining nylon thread.
Recoiling the new nylon thread
Cut approximately 4 metres of nylon thread. Hold
both extremes of the thread and fold in two. Insert the
nylon thread on the spool and coil the two extremes in
the same direction but each on its own track.
Mounting
1. Block both extremes of the nylon thread onto
grooves B.
2. Reinsert the spool back into place and place the
extremes of the nylon thread through eyelets A.
3. Pull the nylon thread until you have pulled some
12 cm.
4. Tighten the knob.
A A
6.2.5. HOLDING THE CABLE EXTENSION
Only use cable extensions that are certified for
outdoor use. The cable section must be at least 1,5
mm 2
, the cable will have a maximum length of 25 m
and it must be fully unrolled before starting to work.
Fix the cable extension to the
fixing hook provided as seen in
the figure.
6.3. START UP
6.3.1.CHECK POINTS BEFORE STARTING
or wrongly regulated.
Use this machine for the purpose for which it was
designed. Any other use may be dangerous for the
user to the machine and for people, animals and
things you may have around.
The electric current must conform to those stipulated
in the characteristics label on the machine.
Verify that :
- The machine completely and look for loose parts
- The protector is properly attached to the machine.
B
- Verify that the head is not damaged.
Press, repair or replace everything you need before
using the machine.
Do not use attachments on this machine out of our
recommendations because their use may cause
serious injury to the user, the machine and the people,
animals and things close to the machine.
B
Before starting the machine make sure that all moving
parts of the machine are not in contact with any object.
6.3.2. CHECKING THE ELECTRIC CONNECTION
Ensure that the cable and the plug are in a perfect
state and that they comply with the machines
prerequisites. Place the cable elongator in such a way
32/120
Do not use this machine if it becomes damaged
(screws, nuts, etc.) and damages.