Swann MSOLARVER15L Manual De Instrucciones página 7

4
Connect the solar panel to your camera, as shown below.
First, pull out the port cover on the back of your camera and replace with the supplied
replacement port cover which has a USB connector cutout. Use a paper clip or sim ejector tool to
insert the tab of the replacement port cover into the slot, if necessary. Make sure the port cover is
sealed properly; it should fit flush without gaps. Then, connect the round end of the USB charging
cable to the solar panel and the micro USB end to the camera.
SWWHD-INTCAM
Replacement
All done! The solar panel is now ready to charge your camera when the sun is out! Use the app
to check your camera's charging status and battery level at any time.
INSTALLING THE SOLAR PANEL
SWIFI-CAM
Reset
OPEN
port cover
Tighten screw cap to
secure connector
USB charging cable
EN
7