Important Safety Instructions; Basic Setup - Fellowes Microshred 12Ms Guia De Inicio Rapido

A.
B.
C.
D.
E.
CAPABILITIES
Will shred: Paper, plastic credit cards, staples and small paper clips
Will not shred: Adhesive labels, continuous form paper, transparencies, newspaper, cardboard,
large paper clips, folders, X-rays, CD/DVD or plastic other than noted above
Paper shred size:
Micro-Cut .....................................................................5/32 in. x 1/2 in. (4mm x 12mm)
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
manual. Read the entire instruction manual before operating shredders.
to off or unplug when not in use.
openings. If object enters top opening, switch to Reverse ( ) to back out object.
shredder. DO NOT USE "CANNED AIR" OR "AIR DUSTERS" ON SHREDDER. Vapors
from propellants and petroleum based lubricants may combust causing serious
injury.
Do not place near or over heat source or water.
BASIC SET UP
CASTER INSTALLATION
1
2
F.
G.
H.
KEY
A. SafeSense
B. Paper entry
C. Control Panel
D. Pullout bin
E. Casters
F. Disconnect power switch
2 3
G. See safety instructions
Technology
®
H. LEDs
1. ON/OFF (white)/Bin Open
2. Overheat (red)
1. Reverse
3. Bin full (red)
2. Forward
4. Remove Paper (red)
5. SafeSense
1. OFF
2. ON
Maximum:
Sheets per pass ........................................................................................................... 12*
Cards per pass ............................................................................................................... 1*
Paper entry width .....................................................................................8.7 in. (220mm)
* 8.5 in. x11 in., 20lb., (75g) paper at 120V, 60 Hz, 3.9 Amps; heavier paper, humidity or other than
rated voltage may reduce capacity. Maximum recommended daily usage rates: 1000 sheets per day, 25
credit cards.
Fellowes SafeSense ® shredders are designed to be operated in home and office environments ranging
between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
position to operate shredder. In case of emergency, move switch to OFF ( )
position. This action will stop shredder immediately.
voltage and amperage designated on the label. The grounded outlet or socket
must be installed near the equipment and easily accessible. Energy converters,
transformers, or extension cords should not be used with this product.
4
indicator (yellow)
®
ENGLISH
Model 12Ms
( )