Cooper Portfolio LuxWire Instrucciones De Instalación página 3

1.2. Down Light Installation Instructions
1. Cylinder comes fully assembled when received. To
install remove 2 #8-32 flat head screws from canopy
located outside of the 2 aircraft cables. The canopy
can fall out of the way to expose the mounting strap.
(Figure 4)
Figure 4.
Strap
Canopy
Aircraft Cables
2. Connect the mounting strap to the J-Box (supplied by
others) with 2 #8-32 screws. (Figure 2)
3. For options with the driver in the canopy, there is a
splice cover to provide a barrier to the ceiling and
the driver is attached to the mounting strap. Make
connections to Driver following local code and seeing
the wiring diagrams mentioned in the electrical section.
(Figure 3)
4. For remote driver options, connect remote driver to
J-box following the instruction provided in the kit. Then
connect the remote harness to the aircraft cable using
the orange connectors attached to the ends of each
side.
5. Once wiring is complete, slide the canopy back up to
the ceiling and secure in place with 2 #8-32 flat head
screws. Clip zip ties that is holding the aircraft cable, so
the cylinder can hang free.
Installation Instructions – Portfolio LuxWire™ Cylinders
6. To adjust height, the cylinder top needs to be removed
by removing 4 screws, then use cable fittings located
on the cylinder on the cylinder top. Push the fitting to
pull the cable through and be sure to clip the ends so
the cable does not contact any metal components.
Then reinstall to cylinder.
2. Trim
1. Remove lower trim from protective packaging. Rotate
side clips (3) outwards. (Figure 5) Remove LED Engine
from protective packaging.
Figure 5.
2. Insert LED engine on to trim assembly. Align post on
LED engine with slot on trim assembly. (Figure 6)
Figure 6.
#8-32 Flat Head
Screw (2X)
Cooper Lighting Solutions
IB520105ML Installation instructions
3