Problems Disposal - Saivod VS2814 Manual De Usuario

Moving your electric bottle cooler
 Remove all the bottles.
 Securely tape down all loose items inside your electric bottle cooler.
 Turn the leveling legs up to the base to avoid damage.
 Tape the door.
 Be sure the electric bottle cooler stays in the upright position during transportation.

Problems Disposal

You can solve many common electric bottle cooler problems easily, saving you the cost of a possible
service call. Try the suggestion below to see if you can solve the problem before calling service center.
PROBLEM
Electric bottle cooler does not operate.
Electric bottle cooler is not cold enough.
The light does not work.
Vibrations.
The electric bottle cooler seems too make
too much noise
The door will not close properly.
LED could not display.
LED display error.
Buttons are not functional.
When the time comes to eliminate this product, please consider the environmental impact and
take it to recognised recycling facility instead of disposing it with general household waste. Take
the equipment to a waste disposal site. Plastic and metal parts that are used in the construction
of this appliance can be separated into pure grade which allow recycling. Ask to your service
centre for details. Everyone of us can participate on the environmental protection.
VS2814.indd 21
POSSIBLE CAUSE
Not plugged in using different voltage. The circuit
breaker tripped or a blown fuse.
Check the temperature control setting.
External environment may require a higher setting.
The door is open too often.
The door is not closed completely.
The door seal does not seal properly.
The electric bottle cooler does not have the correct
clearance.
Check the service center.
Check to assure that the electric bottle cooler is
level.
The electric bottle cooler is not level.
Check the fan.
The electric bottle cooler is not level.
The doors were reversed and not properly installed.
The seal is weak.
The shelves out of position.
Main control board does not work.
PCB Problem.
There is some problem with the plug.
Weak quality of display.
Temperature point is out off.
Temperature controller panel is damaged.
GB
21
8/18/2016 5:06:03 PM