How To Operate - Nostalgia Products Hollywood HHP100 Instrucciones Y Recetas

Máquina de palomitas de aire caliente
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

HOW TO OPERATE

Before first use, clean the inside and outside of the unit by wiping with a moist,
non-abrasive sponge, towel or cloth and then wipe with a non-abrasive dry towel.
Make sure the Top Housing is securely attached to the Base before starting.
1.
First, find a flat surface near an electrical outlet before starting. Make sure your cord
is away from any water source. It is acceptable to use an extension cord if needed.
2.
Gather your popcorn making supplies: popcorn, seasonings, bowls or bags for holding the
popcorn, and Kernel Measuring Cup. Kernel Measuring Cup is included with your unit.
3.
Plug in the appliance while switch is flipped to OFF position. Remove Kernel Measuring Cup.
4.
Turn appliance ON by flipping the switch on the Base. Allow the appliance
to run for about 2 minutes to heat up Popping Chamber.
5.
While Popping Chamber is heating, fill Kernel Measuring Cup with corn kernels (6 tbsp).
6.
Turn unit OFF.
7.
Place bowl underneath the opening in Top Housing to collect popcorn.
8.
Pour kernels into the top of the unit and replace Kernel Measuring Cup.
9.
Turn the unit ON. In no time at all, you will hear the popping begin. Fresh, hot popcorn
will begin to burst out of the opening in the Top Housing and into the bowl.
10. Once the kernels have stopped popping, turn unit OFF.
11. Tip HOT AIR POPCORN MAKER forward to make sure that
all of the popcorn is out of the machine.
12. Always allow 15 minutes between popping sessions to allow
machine to cool so that it does not overheat.
7

Publicidad

Tabla de contenido
loading

Tabla de contenido