Echo I - START Instrucciones De Instalación Y Operación página 2

2
:
ASSEMBLY
1. Thread new pawl catcher CW onto crankshaft end. Turn
pawl catcher and crankshaft CW until the piston rests
firmly against piston stop, preventing crankshaft from further
rotation.
2. Use pliers to clamp pawl catcher, then turn CW until tight.
NOTE:
Do not use excessive force when clamping pawl catcher to
avoid damage to assembly.
3. Hold spacer with triangular tab to the left. Insert square
flange of spacer over pawl catcher and under upper engine
cover mounting flanges when viewed from the rear. Align
screw holes and secure spacer to engine using four (4)
screws removed from original starter assembly.
NOTE:
When installing starter assembly to spacer, pull starter rope
six (6) inches until starter assembly fits flush with spacer.
4. Install the i-Start assembly to the spacer with starter
handle positioned to the left when viewed from the rear.
Secure with three (3) tapping screws supplied.
5. Remove piston stop. Slowly pull starter rope to verify engine
rotates freely. If engine does not rotate freely, check spacer
and starter alignment.
6. Install spark plug and connect spark plug lead.
NOTE:
When the starter is correctly installed, you will hear a
clicking sound when the starter rope is pulled out then
returned.
- S I
TART NSTALLATION
/O I
PERATING NSTRUCTIONS