Aux Output; Headphone Jack - JB Systems PMD 8 Instrucciones Para El Uso

C. AUX SECTION
1. AUX INPUT
Used with 1/4" stereo jack, you can connect it with stereo equipment or other
external signal.
Tip = left signal
Ring = right signal
Sleeve = negative

2. AUX OUTPUT

Connect this jack with the input jack of a monitor amplifier.
3/4. STEREO RECORDER AND PHONO JACK
(3)These jacks can be connected with a tape deck/recorder,
to inject a signal from a tape deck into the mixer.
(4) These jacks can be connected with a tape deck/recorder,
to record the mixed output from the mixer.

5. HEADPHONE JACK

You can monitor master sound or a certain channel through the headphones.
6. PRE-FADER LEVEL (PFL) CONTROL
Push this switch when you want to listen to a certain channel, the LED will
light up. Release the switch when you want to control the master output.
7. HEADPHONE VOLUME CONTROL
With this control you can adjust the output level of the headphone.
8. AUX INPUT LEVEL CONTROL
Controls the input level from AUX INPUT (1) and PLAY IN (3).
9. MONITOR HIGH FREQUENCY EQUALIZATION CONTROL
Correction of ±15dB on a frequency of 12KHz.
Works on the AUX output.
10. MONITOR LOW FREQUENCY EQUALIZATION CONTROL
Correction of ±15dB on a frequency of 100Hz.
Works on the AUX output.
11. AUX EFFECT CONTROL
Controls the effects on AUX INPUT (1) and on PLAY IN (3).
12. CHANNEL SWITCH
When you want to enable the AUX INPUT (1) or the PLAY IN (3), press the
button. If this switch is not pressed, the AUX input is disabled.
13. PFL SWITCH CONTROL
When you want to control the AUX INPUT signals, press the button.
14. MASTER MONITOR CONTROL
Controls the volume of the AUX OUTPUT.
PMD8 – PMD12 4