Pedal Programming - Studiologic VMK-88 plus Manual Del Usuario

VMK88 MANUAL PEDALS
plus
PROCEDURE: PEDAL PROGRAMMING
We will program PEDAL INPUT 1 to transmit Sustain. For this procedure you will need a Sustain
Pedal. Any polarity pedal will work.
TIP: The four PEDAL INPUTS may be programed to transmit anything from Sustain to Volume to
even Modulation. A PEDAL INPUT, when connected to a Volume Pedal , can transmit the same
CNTRL Values as the SLIDERS or KNOBS. Remember, you have four PEDAL INPUTS to work
with. Imagine in a live set-up, two volume pedals set-up to control two different sounds. In our
set-up you would program PEDAL 1 so its Polarity would be DN>UP, and PEDAL 2 so it's Polarity
would be UP>DN. By pressing down on both volume pedals, you would fade out of one sound and
fade into the other! All without awkward foot movement.
1)PRESS EDIT
2)PRESS PEDAL
In this example set the Midi
Channel to 1
Remember the sustain
Pedal must be plugged
into PEDAL INPUT 1
3)PRESS PAGE UP
We need to set the
CTRL Change to 64
That's the Midi Spec for
Sustain Pedal.
4)PRESS PAGE UP
Set the Value Min. to 0
In this case any Value below
<64 will transmit an off Message
5)PRESS PAGE UP
Set the Value Max. to 127
In this case any Value above
>64 will transmit an on Message
16