Bosch MSGP3L Manual Del Usuario página 16

en Overview of illumination modes
modes illumination of Overview
Overview of illumination
modes
modes illumination of Overview You can find an overview of the different il-
lumination modes here.
Illumination
mode
The LEDs light
up pink.
The LEDs light
up white.
The LEDs flash
twice.
The LEDs light
up green.
The LEDs light
up or flash red.
The LEDs do
not light up.
solution nutrient of Quantity
Quantity of nutrient solution
You can find an overview for the status of
solution nutrient of Quantity
the nutrient solution here.
Illumination
mode
The LEDs flash
white twice.
16
Status
The device is in the
sprouting phase or holi-
day mode is switched
on.
One or more height
modules are inserted.
The device is in stand-
ard mode.
¡ Manual switch
between sleep mode
and standard mode
is confirmed.
¡ The maximum capa-
city of the water bowl
has been reached.
The LEDs flash white
twice.
Descaling has started
and the pump is run-
ning.
→ "Troubleshooting",
Page 18
¡ The device is in the
sleep mode.
¡ → "Troubleshooting",
Page 18
Status
The maximum capacity
of the water bowl has
been reached.
Illumination
mode
The LEDs light
up blue for
5 seconds
while the pump
is running.
The LEDs flash
blue 10 times
every
3 minutes. The
pump has
switched off.
information General
General information
Do not install the device under the following
information General
conditions:
¡ in direct sunlight
¡ close to air-conditioning systems and
heaters
¡ outdoors
¡ in areas at risk from frost
¡ in areas with an ambient temperature ex-
ceeding 36 °C
¡ on vibrating surfaces, e.g. on washing
machines
¡ on magnetic metal surfaces
device the Preparing
Preparing the device
device the Preparing → Fig. -
2 3
Notes
¡ Clean all parts before using for the first
time.
¡ Put the cleaned and dried parts out
ready for use.
device the Installing
Installing the device
device the Installing → Fig. -
4 5
solution nutrient Mixing
Mixing nutrient solution
solution nutrient Mixing
Add 1 measuring spoon (2ºg) of nutri-
▶
ents to 1ºlitre of fresh tap water.
→ Fig.
6
Notes
¡ On initial start-up add 1 measuring
spoon (2 g) of nutrients to 1.5 litres of
fresh tap water.
Status
Only a little nutrient
solution remains in the
water bowl.
The water bowl contains
too little nutrient solu-
tion. Nutrient solution
should be topped up.
Printed on 100% recycled paper