Publicidad
Argia XL LED
PRECAUTIONS:
• Keep out of reach of children.
• Do not immerse this product in water or handle it with wet hands.
• Do not hit the product.
• Do not install the product where there are heat sources or moisture
concentrations.
• Do not handle the product while it is in operation and let it cool before
touching it with your hands.
• The product must not be covered by thermal insulation material in any
case.
• Keep a minimum distance of 1m with the surface or object to be illuminated.
• If the product is damaged, replace it immediately with a new one.
• Disconnect the power before installing the product.
• This product contains components sensitive to static electricity and a
discharge on it could destroy or damage its components.
• Before proceeding with any handling or maintenance, make sure that the
appliance is completely disconnected from the power supply.
• The replacement or maintenance of any component must be done with
the same elements recommended and supplied by the manufacturer. If
this is not the case, any incident in an installation that has not been carried
out in accordance with this instruction sheet will be the responsibility of
the installer.
PLED
Nº LED
32W
48W
32 LED
64W
75W
DEGREE OF PROTECTION
Degree of waterlightness
Module impact resistance
• The light source of this luminaire must be replaced only by the manufacturer,
its technical service or equivalent qualified person.
• The luminaire should be placed so that a prolonged look at the luminaire is
not expected at a distance closer to 4.67m.
1/10
noviembre 2019
676
MAX.
MAXIMUM
WEIGHT
HEIGHT OF
SURFACE WIND
INSTALLATION
EXPOSED
0,156m 2
9 Kg
20
IP66
IK09
[GRÁFICOS: Unidades en mm/ GRAPHICS: Units in mm/GRAPHIQUES: Unités en mm/GRÁFICOS: Unidades em mm]
WARNING
BEFORE INSTALLING THIS PRODUCT, PLEASE READ THE
INSTRUCTIONS CAREFULLY AND STORE THEM IN A
SAFE PLACE.
THE INSTALLATION SHOULD BE CARRIED OUT BY
TRAINED STAFF.
INCORRECT HANDLING OF THE PARTS OR THE
LIGHT FIXTURE ITSELF MAY IMPAIR THE PROPER
PERFORMANCE OF THIS PRODUCT. IN THIS CASE,
THE MANUFACTURER GUARANTEE SHALL BE DEEMED
VOID.
THE MANUFACTURER GUARANTEE SHALL BE DEEMED
VOID: IF THE INSTALLATION IS NOT PERFORMED IN
ACCORDANCE WITH THE SPANISH LOW VOLTAGE
ELECTROTECHNICAL REGULATION 2002 (REBT 2002).
THE APPLICATION OF IBC BT09-4 OF REBT (INSTALLATION
OF LINE AND LIGHT FIXTURE SURGE PROTECTORS) IS
ESSENTIAL FOR INDUSTRIAL AND PUBLIC LIGHTING
INSTALLATIONS. THE GUARANTEE DOES NOT COVER
AGAINST DAMAGES CAUSED BY SURGES IN LIGHT
FIXTURES WITHOUT SURGE PROTECTORS INSTALLED.
ATTENTION!!!
OBSERVE
PRECAUTIONS
HANDLING
SENSITIVE DEVICES.
FOR
ELECTROSTATIC
Publicidad
