Installation Instructions - Honeywell TCPA1BS Guia De Inicio Rapido

1
TCPA1BS

Installation instructions

3a
General Information
The TCPA1BS is a wireless keyfob that may be worn around the neck, on a wrist band or as an apparel clip that
may also be mounted to a desk. Pressing the keyfob button for at least 300 ms and releasing it, sends a signal
to the panel.
Registration and Configuration
1.
4
*https://international.mytotalconnectcomfort.com
2. To start registration, press the keyfob button for 5 seconds.
Battery Replacement (see figure on first page)
The TCPA1BS is powered by a long-life Lithium battery that may be replaced when a low battery is eventually
indicated by the control unit.
1. Remove 4 screws and lift off cover.
CR123 LITHIUM 3V
2. Using a small flat-blade screwdriver remove old battery.
3. Insert new battery by placing new battery under the gold tab and then pressing down.
Ensure the positive (+) side of battery is face up after installation.
4. Align cover and attach with 4 screws.
NOTE: When replacing the battery, wait a minimum of 10 seconds prior to installing the new battery.
NOTE: Although water-resistant, please do not immerse in water at a depth below 10cm for more than 1 hour.
Specifications:
Unit Dimensions:
LED:
Battery:
Operating Temperature:
CAUTION:
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO BATTERY MANUFACTURER
INSTRUCTIONS AND APPLICABLE REGULATIONS.
TCPA1BS V2.indd 2
1.8m
2a
2
1
https://international.mytotalconnectcomfort.com
https://
WEB
WEB*
1
2
39 mm diameter
lights when unit transmits
3-Volt CR2032 Lithium
-10°C to +55°
1
3b
5
1
2
English
x2
2.5min
2
06/06/2016 11:44