Jean Louis David JLD-2101 Manual Del Usuario página 11

2. Cutting-length adjustment ring (0.8 / 1.1 / 1.4 / 1.7 / 2.0)
3. Cutting speed adjustment button (+)
4. On/off button
5. Cutting speed adjustment button (-)
6. LCD display
7. Battery (built-in)
8. Charging jack
9. Cut comb (3 mm)
NOTE: Always ensure your hair is clean, well combed, tangle-free and dry before using the appliance. Do not use hair sprays,
water vaporizers or any other vaporizers when operating the appliance.
NOTE: If you are not used to cutting hair, begin with the cut comb for a longer hair length and then reduce it, to avoid cutting
more hair than desired.
NOTE: When using the appliance for the first time, first try it on an area with light hair growth.
NOTE: Use a slow and controlled movement. Do not force the appliance through the hair faster than it can cut it. To control the
result during cutting, regularly comb the hair in the desired style.
NOTE: During the operation, shake or blow off the hair from the cutting head and cut comb, if too much hair is caught in them.
NOTE: It is not recommended to operate the appliance while charging the battery, if it is connected to the charging adapter /
power supply, to avoid the battery overheating and extending charging time.
Charging the battery
— The battery capacity (in percentage) is indicated on the LCD display during operation.
— If it shows a low battery capacity (< 5%), the symbol
appliance.
— Connect the charging adapter with the charging jack on the appliance and plug it into a suitable power socket.
— The battery capacity and symbol
— After the battery is fully charged, the battery capacity 100% and symbol
— Disconnect the charging adapter from the appliance and power supply.
Locking the on/off button
— To avoid accidental switching-on, keep pressing the on/off button for approx. 2 - 3 seconds to lock it. The symbol
on the LCD display and goes out afterward.
— Keep pressing the on/off button for approx. 2 - 3 seconds to unlock it.
— The on/off button cannot be locked while charging the battery.
Cutting the hair
— Always switch off the appliance when attaching, detaching or
changing the cut comb.
— Select the suitable cut comb (3 mm / 6 mm / 9 mm / 12 mm) for
the desired hair length. Ensure the cut comb is properly fixed on
the cutting head.
— Use the guide comb for easy handling when cutting the hair on
both sides of the head, especially around the ears.
— Rotate the cutting-length adjustment ring left- and rightward to
adjust the desired hair length according to the scales (0.8 / 1.1 /
1.4 / 1.7 / 2.0).
— Press the cutting speed adjustment buttons "+" and "-" to select the desired cutting speed. The selected setting (5000 /
5500 / 6000 / 6500 / 7000 RPM) is indicated on the LCD display.
— Press the on/off button to switch on the appliance.
— Comb your hair in the direction of hair growth.
— Press the cut comb against your head, start by cutting the sides of your hair from the bottom of the head upwards. Slowly
move the appliance up towards the top of the head, cutting small amounts at a time.
— Repeat at the back of the head.
— Cut the hair at the top of your head from front to back.
— After the operation, press the on/off button to switch off the appliance.
INSTRUCTIONS FOR USE
flashes on the LCD display. Press the on/off button to switch off the
are indicated on the LCD display during charging.
11. Cut comb (9 mm)
12. Cut comb (12 mm)
13. Guide comb (right side)
14. Guide comb (left side)
15. Charging adapter
16. Cleaning brush
17. Lubrication oil
flash on the LCD display.
11
flashes