Led Display; Control Keys - Cameo PHANTOM H2 Manual De Usuario

4 DMX IN
Male 3-pin XLR jack for connection of a DMX controller.
DMX OUT
5
Female 3-pin XLR connector to transmit the DMX control signal.
6

LED DISPLAY

4-digit LED display for display of the DMX start address and other information.

CONTROL KEYS

7
MODE – press MODE to enter the Edit menu to exit the menu, press MODE again. The display will now show rEAd.
ENTER – press ENTER to go one level deeper in the editing menu and to confirm value or status changes.
UP / DOWN – use the UP and DOWN buttons to change a value, such as the DMX start address or the status of a menu item.
8 WINDOW
Window to monitor the canister fill level. The canister is illuminated to make fill level monitoring easier. In the heating phase, red LEDs are
permanently on. Once the heating phase is over and sufficient haze fluid is available, blue LEDs light up. If insufficient haze fluid is available
for operation, the red LEDs and 2 segments in the displays will begin blinking as a warning signal and the fluid pump will deactivate to pro-
tect the system. Immediately disconnect the hazer from the power supply and top up the haze fluid level. The warning signal for insufficient
haze fluid will also activate even when Dark Mode is activated.
11
6
PHANTOM H2
9
10
11