Publicidad
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 25)
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis must sup-
port HDA to function correctly. Please follow the instructions in our manual and chassis
manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by the
steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to connect
them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel and
adjust "Recording Volume".
Analog Surround
Audio Header
(17-pin HD_AUDIO2)
(see p.1, No. 28)
3W Audio AMP Output
Wafer Header
(4-pin SPEAKER1)
(see p.1, No. 27)
16
OUT_RET
OUT2_L
J_SENSE
MIC_RED
OUT2_R
PRESENCE#
MIC2_R
GND
MIC2_L
1
PIN
18
16
14
12
10
8
2
1
6
4
2
1
Front_L-
Front_L+
Front_R+
Front_R-
This header is for
connecting audio devices
to the front audio panel.
Signal
PIN
Name
SENSE
17
LFE
15
A_GND
13
Surr_Rear_R
11
A_GND
Surr_Rear_L
9
Surr_Side_R
7
A_GND
Surr_Side_L
5
Front_R
3
A_GND
1
Please connect the chassis
speaker to this header.
Signal
Name
KEY
A_GND
Center
A_GND
A_GND
A_GND
Front_L
Publicidad
