Mobile Battery Charger, 12 Vdc - 12 Vdc
Description
Model 339997 battery charger is designed to charge the 12 Volt
battery pack (339804) of 575 series cordless grease guns. The charger's
power source is a standard automotive 12 Vdc accessories outlet.
Specifications
Input
12 Vdc @ 3 Amps
14.5 Vdc (2.5 Amps)
WARNING
Before using the Battery Charger read all instructions
and cautionary markings on the Charger, battery pack, and
products using the battery pack.
To reduce the risk of injury, charge only Nickel-Cadmium type
rechargeable batteries. Other types of batteries may burst
causing injury.
Do not expose the Charger to rain, snow, or frost.
To reduce the risk of damage to electric plug and cord, pull by
the plug rather than the cord when disconnecting the
Charger. Do not abuse the cord. Never carry the Charger by
the cord.
Make sure the cord is located so that it will not be stepped on,
tripped over, or otherwise subjected to damage or stress.
Do not operate the Charger with a damaged cord or plug.
Do not operate the Charger if it has received a sharp blow,
been dropped, or otherwise damaged in any way.
Do not disassemble the Charger.
Do not attempt to charge any other cordless tool or battery
pack with this Charger.
Do not charge the battery pack in a damp or wet location, or
when the temperature is below 32° F (0° C) or above 104° F
(40° C).
Do not store the Charger assembly in locations where the tem-
perature may reach or exceed 122° F (50° C).
This document contains confidential information that is the property of Alemite Corporation
670856
and is not to be copied, used, or disclosed to others without express written permission.
Service Guide
Output
Cord Length
6 Feet (1.8 m)
CAUTION
Alemite Corporation
167 Roweland Drive, Johnson City, Tennessee 37601
www.alemite.com
©
Copyright
Operation
Recharging Hot Battery Pack
When using the gun continuously, the battery pack
will become hot. Allow the battery pack to cool for
approximately 30 minutes before attempting to recharge.
Recharging Normal Battery Pack
1. Position the battery pack into the Charger.
2. Press down to ensure the battery properly engages
with the charger's contacts.
The red lamp on the Charger indicates the battery is
charging in FAST mode.
After normal usage, 1 hour of charge time is required
before the battery is fully charged. A minimum charge
time of 1 to 1-1/2 hours is required to recharge a
completely discharged battery pack.
When the Battery Pack becomes fully charged, the red
lamp turns off and the green lamp (TRICKLE) turns on.
NOTE: The Battery Pack will become
slightly warm to the touch while charging.
This is normal and does not indicate a
problem.
2004 by Alemite Corporation
339997
SER 339997
Revision (4-04)