Setup - Cameo INSTANT FOG 1700 T PRO Manual De Usuario

DEVICE SETTINGS (Settings)
Access the selection menu by pressing MODE. Using the UP and DOWN control keys, now select the "Settings" menu option (note arrow)
and confirm via ENTER.
Settings
ENTER
This will take you to the submenu for setting the following submenu options (select via UP and DOWN, confirm via ENTER, change status via
UP and DOWN, confirm via ENTER):
Settings
Display = Sets the display and control
Settings key illumination and canister
illumination
Settings = Operating mode for DMX signal
DMX Fail interruption
Settings = Automatic locking unit
Auto Lock
Unit
SYSTEM INFORMATION (System Info)
Access the selection menu by pressing MODE. Using the UP and DOWN control keys, now select the "System Info" menu option and confirm
via ENTER.
System info
ENTER
This will take you to the submenu for displaying the device information. Use the UP and DOWN buttons again to select the desired
parameter, then press ENTER to call up the information.
System info
Firmware = Displays the device firmware
Operating H Operating time display of the fog machine in hours
Hours

SETUP

Place the fog machine in a suitable location on its preinstalled rubber feet and follow the instructions under "CAUTION! IMPORTANT
INFORMATION ON FOG MACHINES!" in the safety information of these instructions when doing so.
Display and LEDs
on
Display
off
Display and LEDs
Dark Mode
DMX Fail
Hold
DMX Fail
Stop fog output
Auto Lock Unit
off
Auto Lock Unit
60sec
Display, control key, and
canister illumination permanently on
Display off after 30 seconds of
inactivity, control key and canister
illumination on
Display, control key, and canister
illumination off after 30 seconds of
inactivity
Last command is held
Fog output is stopped
Automatic locking deactivated
Automatic locking activated after
approx. 60 seconds of inactivity
(release by simultaneously holding UP
and DOWN for approx. 10 seconds)
Software Version
Vx.xx
Operating Hours
Total: x
9