Connecting The Water Supply Line - Glacier bay N2441E Guía De Uso Y Cuidado

Installation (continued)
Installing and adjusting the flush
7
button
□
Position the flush button mechanism (QQ) in tank lid so the
single drop button will align with blue button (half flush) on
top of the flush valve and double drop button aligns with
the grey button (full flush).
□
Secure the flush button mechanism (QQ) in the tank lid by
hand tightening the lock nut (1).
□
The rubber tip on the bottom of the push rods leading from
the flush buttons should lightly touch the top of the levers
on the flush valve.
□
To increase the rod length, turn the rod locknut counter-
clockwise to loosen, then rotate the push rod counter-
clockwise to increase exposed length. When the desired
length is achieved, turn the rod locknut clockwise, while
holding the push rod, until it is tightened.
8

Connecting the water supply line

□
Connect the water supply line (not included) between the
tank (A) and shut-off valve.
□
Tighten the tank connection coupling nut ¼ turn beyond
hand tight.
□
Turn on the supply valve and allow the tank (A) to fill.
□
Check for leakage at all connections and tighten or correct
as needed.
NOTE: Do not overtighten the tank connection.
7
Please contact 1-855-434-5224 for further assistance.
HOMEDEPOT.COM