Publicidad
Idiomas disponibles
Idiomas disponibles
Pedestal Base
Illustration 2. Pedestal Base Assembly
Illustration 2a. Pedestal base assembly
X 4
X 4
1.5"
1.5"
IMPORTANT: Do
not use impact gun
for installation of
screws into extru-
sion. Torque not to
exceed 65-70 in-lbs
Illustration 3b. Pedestal bases to worksurface
Illustration 3b. X bases to worksurface
See Instructions for (3a).
Medium Base Mounting Plate
Install 8 Screws
0560087900
04/2020
1. Align holes in base with
bosses in extrusion.
2. Using a 3/8" socket driver,
insert (4) hex head scr-
ews through base into
bosses in extrusion.
3. Align holes in top plate
with bosses in extrusion.
4. Using a hex driver, inert
(4) 1/4 - 20 flathead scr-
ews through top plate
into bosses in extrusion.
Note: Some bases may
come with top plate already
attached to the column.
Large Base Mounting Plate
Install 12 Screws
Installation Packet
Illustration 3a. Pedestal bases to worksurface
1. Align holes in top plate with (2) pilot holes in the
worksurface.
2. Using correct driver and screws (see below) insert
screws through top plate into 2 pilot holes in the
worksurface.
3. Insert remaining screws.
4. Repeat steps 1 through 3 for the remaining bases.
5.
With minimum of 2 people, flip the table upright.
Medium Base
Mounting Plate
X 8
1"
Phillips #2
driver
IMPORTANT: To avoid damage to the product,
do not pivot table upright with weight on the legs.
Instead, lift table while turning and set down
once table is in the correct orientation.
Large Base
Mounting Plate
X 12
1-1/4"
Phillips #3
driver
Page 3 of 3
Publicidad
