Removing The Cover - Signature 6700 Pro Impact Manual De Instrucciones

Adjusting the Arc
The Pro Impact offers both Part Circle (20 –340deg) and Full Circle (360deg)
capabilities within one head and comes preset Part Circle mode at 180deg.
After mounting the head follow these steps to set the arc:
1. Prior to inserting wrench, pry up the lid with a flathead screwdriver.Insert
special wrench (#8601) around the hex on the retainer nut and place the bottom
edge of the lid over the tab at the top of the wrench.
2. Locate the 2 adjusting trip collars, which are below the actual sprinkler head
and above the white seal. Both trip collars have 2 tabs on them.
3. Now spread the 2 adjusting trip collars by pushing on one of the tabs to the
desired Part Circle degree. Make sure that the reversal trip mechanism, which
is mounted to the adjustment tab, is NOT in the horizontal position (flipped up)
and is in the vertical position (flipped down) between the 2 adjusting trip collars
in order to reverse properly in the Part Circle mode.
4. Make the final fine tune
adjustments while the system is
running.

Removing the Cover

The Pro Impact cover comes standard with a heavy-duty black cover and has
an optional lavender cover (#6701) for reclaimed water use. The cover can
easily be removed with a flat-head screwdriver. Follow these steps to remove
the cover:
1. Remove the small black plug from the middle of the cover by prying it up with
a flat-head screwdriver. Make sure to save the black plug for reassembly.
2. Under the cap there are four holes. Align one of the holes with one of the two
flanges that are holding the cover on. Then slide the screwdriver through that
hole and on top of the flange. Now pry the screwdriver up, thus putting pressure
on the flange and pull the cover up with the other hand. The cover will pop off
with ease for easy access to the impact.
5. To convert the Pro Impact to Full
Circle operation, just flip up the vertical
reversing trip mechanism so it is in the
horizontal position (flipped up).
2