Ryobi EPN6082C Traducción De Las Instrucciones Originales página 3

SPECIAL SAFETY RULES
■ Wait for the cutter to stop before setting the tool
down. An exposed rotating cutter may engage the
surface, leading to possible loss of control and serious
injury.
■ Hold the tool by insulated gripping surfaces only,
because the cutter may contact its own cord. Cutting
a "live" wire may make the exposed metal parts of the
tool "live" and could give the operator an electric shock.
■ Use clamps or other practical ways to secure and
support the workpiece to a stable platform. Holding
the workpiece by hand or against the body leaves it
unstable and may lead to loss of control.
ADDITIONAL SAFETY RULES
■ Do not remove splinters or saw dust while tool is
running.
■ Only plane with sharp blades, avoid metals (nails,
screws).
■ Do not reach into the danger area of the tool when
plugged in.
INTENDED USE
■ Planing wood (removing an even layer to provide a
smooth, flat finish)
■ Rebating wood
The product is not intended to be used for stationary
planing.
MAINTENANCE
■ The tool should never be connected to a power supply
when you are assembling parts, making adjustments,
cleaning, performing maintenance, or when the tool is
not in use. Disconnecting the tool will prevent accidental
starting that could cause serious injury.
■ When servicing use only identical Ryobi replacement
parts. Use of any other parts may create a hazard or
cause product damage.
■ Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
■ Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils come in contact with
plastic parts. They contain chemicals that can damage,
weaken or destroy plastic.
■ Electric tools used on fiberglass material, wallboard,
spackling compounds, or plaster are subject to
accelerated wear and possible premature failure
because the fiberglass chips and grindings are highly
abrasive to bearings, brushes, commutators, etc.
Consequently, we do not recommend using this tool for
extended work on these types of materials. However, if
you do work with any of these materials, it is extremely
important to clean the tool using compressed air.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories and
packaging should be sorted for environmental-
friendly recycling.
SYMBOLS
Safety alert
V Volts
Hz Hertz
Alternating current
W Watts
n No-load speed
0
Revolutions or reciprocations per minute
Please read the instructions carefully before
starting the machine.
Class II, double insulated
Maximum planing capacity
CE conformity
GOST-R conformity
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
Maximum planing capacity
EN
English
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
EL
TR
1