WorldBrands JET SURFER Manual De Instrucciones

PREPARATION
Insert the antenna: Insert the antenna into the hole at the top of the controller, and tighten
it. Extend the antenna to its maximum length. The range of the transmitter is 5 meters.
Install the batteries:
On the transmitter: Remove the screw to open the battery compartment cover; insert 4 AA
batteries in the battery compartment with correct polarity; close the battery compartment.
On the jet-ski: Remove the screw from the front of the jet-ski to open the battery compartment;
insert 1 AAA battery in the battery compartment with correct polarity; close the jet-ski's cover.
NOTE: Make sure that the safety rubber is positioned so that the seal is hermetic.
CAUTION!: Do not place hands near the propeller.
TRANSMITTER FUNCTIONS
Function light
Left Propeller
Right Propeller
LEFT BUTTON RIGHT BUTTON
EN
INSTRUCTION
MANUAL
+8
MOVEMENTS
SPECIAL TIPS
If some water enters in the interior of the jet-ski it can not work in a normal way.
Please stop using the jet-ski inmediately, unscrew the screw on the bottom and separate the
jet-ski's body.
Dry the jet-ski with an electric hair dryer and fix the screws.
USE RECOMENDATIONS
•
Select clear, streamless waters.
•
Use it in pools or shallow ponds.
•
Do not use this toy in salt water, it can cause
damage the rotor.
•
Do not operate the toy in swimming pools
or places where people are swimming, it
may hurt someone.
•
Dry the toy with a cloth after playing.
•
When you finish playing remove the batteries.
TROUBLESHOOTING
PROBLEM CAUSE
The jet-ski is not - The battery may be low
responding - Controller may be low on battery
- The controller and the jet-ski may not
be paired correctly
The jet-ski responds - Controller batteries may be low
slowly - A controller using the same
frequency may be in use nearby
CAUTION
Battery warnings:
- Non-rechargeable batteries are not to be recharged.
- Rechargeable batteries must be removed before being
charged. (Transmitter only)
- Rechargeable batteries have to be charged only under an
adult supervision.
- Batteries have to be inserted with correct polarity.
- Exhausted batteries have to be removed from the toy.
(Transmitter only)
- The supply terminals are not to be short-circuited.
- Do not mix old and new batteries. (Transmitter only)
- Only batteries of the same or equivalent type as recommended
must be used. Do not mix alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries. (Transmitter only)
FRESHWATER USE ONLY.
ALWAYS AVOID SALT WATER.
Through this Worldbrands SL declares that the toy meets the essential requirements and other
relevant provisions of the Directive 1999/5 / EC.
You can view the Declaration of Conformity, Doc Jet Surfer XT580738, on the following link:
http://www.worldbrands.es/es/declaraciones-de-conformidad
•
Do not leave the toy for long periods of time
near sources of heat or in direct sunlight; and
avoid leaving the toy nor the transmitter all
night outdoors.
•
Interference from high voltage lines, radios or
other toys may occur with the same frequency.
If this happens look elsewhere without inter-
ference to play.
SOLUTION
- Replace the battery in the jet-ski
- Replace the batteries in the controller
- Remove the batteries and place
them again.
- Replace the batteries
- Move to another area outside of the
other controller
Care and maintenance:
- Take off the batteries from the transmitter if the vehicle has
not been used for a long period of time.
- After each usage, clean and dry the inside of the jet-ski.
- Never leave the product under a direct hot source.
TRANSMITTER
Power supply:
Rating: DC 6V
Batteries: 4 x 1.5V AA/LR6/AM3
(Not included)
JET-SKI
Power supply:
Rating: DC 1,5V
Batteries: 1 x 1.5V AAA/LR03
(Not included)
WorldBrands: C/ Pouet de Nasío
s/n parcela 5 nave B2 Sector 14.
46190 - Ribaroja del Turia (Valencia,
Spain)