Publicidad
During Assembly
an.
When
encountering the information
icon, please refer to the relevant
assembly step for additional comments and
assistance.
This icon
indicates
that the installer should
be
inside the product.
Attention
This
icon indicates
that the
installer should
be
outside the
product.
During assembly
use
a
soft surface
below the
parts to avoid scratches and damages.
Step
1: If
you've purchased
a
WPC
Floor Kit,
do not assemble profile #8851!
Step 8:
If
you're installing
a
WPC
Floor Kit,
measure and cut
floor
board
#
8912.
Step 18: Matte
side
of
all
product's panels should
be
facing out!
Use
mild
soap
if
needed to
ease
sliding of profiles
&
panels.
Step 22:
It
is
recommended to insert
screws
#411
as
preparation for mounting
shelves. If
you've
purchased
a
shelf kit,
mount
a
maximum of
2
shelves per post.
Step 26: Note the bracket's direction
as
shown
in
the drawings, make
sure
the bracket
is
in
line
with the gutter
profile.
Step 27: Note the bracket's direction and make
sure
the
screws are
positioned inside the profile's
channels
as
shown
in
the drawings.
Step 28:
It
is
recommended to insert
screws
#411
as
preparation for mounting
shelves. If
you've
purchased
a
shelf kit,
mount
a
maximum of
2
shelves per post.
Step 32:
If
you've purchased the Yukon 11x21.3 Storage
Shed, please
continue building the
walls,
adding the additional bracket and inserting
screws
#411
as
preparation for mounting
shelves,
as
you've done
in
the
last
4
steps.
Step 33:
It
is
recommended to insert
screws
#411
as
preparation for mounting
shelves. If
you've
purchased
a
shelf kit,
mount
a
maximum of
2
shelves per post.
Step 41:
Before
inserting the
screws, make sure
the internal metal profiles
are
not protruding and
are
well connected
with
one
another inside the aluminum
profiles.
Step 44:The sticker must
be
placed on
a
clean and
dry
surface.
Step 53: Slow down and
be
careful when sliding the panels
in.
Step 56: Make
sure
the distance between the wall's aluminum profiles and
gutter
is
identical prior
to
tightening
the
screws
on
the
inside.
Step 73: Make
sure
the
shed
is
leveled prior to anchoring it to the surface
of your choosing.
Use
suitable
screws
and plugs (not supplied).
*Tighten
all screws
when completing assembly.
Do
not tighten
screws and nuts
(411 &
466)
until completion of assembly
process.
These
2
icons
indicate
if
screws'
tightening
is
required or not.
A
Note: Anchoring this product to the ground
is
essential
to
its
stability
and rigidity.
It
is
required to complete this stage
in
order for your warranty to
be
valid.
Publicidad
