Uline H-8935 Manual De Instrucciones página 2

3. With another person, lift the platform until roller
pins meet the latch stops located on each side of
platform.
4. Lift latch stops. Keeping the latch stops lifted,
continue lifting the platform until it is fully raised.
(See Figure 2)
Figure 2
5. While keeping the platform raised, place the pin
from step 2 into the hole in the roller track closest to
the hinge. (See Figure 3)
Figure 3
INSTALLING ORANGE SPRING
1. On the side of the base with roller tracks, insert
the orange spring into the spring pocket. Ensure
alignment tab is inside the spring. (See Figure 4)
Figure 4
Alignment Tab
PAGE 2 OF 12
INSTRUCTIONS CONTINUED
2. Firmly holding the spring a few coils down from the
3. Remove the pin from its current location in the roller
4. Press down on platform until the two latch stops fall
5. Lift damper back into place and secure with pin.
6. Secure spring with the safety lock.
INSTALLING ADDITIONAL SPRINGS
1. Additional springs can be installed through the
2. Secure the bayonets by placing them into the
3. For spring configurations, see the Spring Selection
top, compress the spring and slide it into the upper
spring pocket. Ensure the spring is fully seated in
both the upper and lower pockets.
WARNING! Do not hold the top coil of the
spring. Doing so may cause hands and fingers
to be crushed when sliding in the spring.
track. The platform should now remain elevated.
back into place behind roller pins. (See Figure 5)
bayonet openings as needed. (See Figure 6)
Figure 6
Safety
Lock
Bayonet
openings and turning clockwise. Secure the
bayonets with the safety lock.
chart on page 3.
Figure 5
0621 IH-8935