Residual Risks - Black+Decker BDC2A Traducción De Las Instrucciones Originales

ENGLISH
The charger must be placed in a well
u
ventilated area when charging.

Residual risks

Additional residual risks may arise when
using the tool which may not be included
in the enclosed safety warnings. These
risks can arise from misuse, prolonged
use etc. Even with the application of
the relevant safety regulations and the
implementation of safety devices, certain
residual risks can not be avoided. These
include:
Injuries caused by touching any
u
rotating/moving parts.
Injuries caused when changing any
u
parts, blades or accessories.
Injuries caused by prolonged use of a
u
tool. When using any tool for
prolonged periods ensure you take
regular breaks.
Impairment of hearing.
u
Health hazards caused by breathing
u
dust developed when using your
tool (example:- working with wood,
especially oak, beech and MDF.)
Symbols on the charger
The following symbols are shown on the
appliance along with the date code:
Warning! To reduce the risk of
injury, the user must read the
instruction manual.
Do not attempt to charge dam-
aged batteries.
The charger is intended for
indoor use only.
4
(Original instructions)
Electrical safety
#
Your charger is double insu-
lated; therefore no earth wire is
required. Always check that the
mains voltage corresponds to the
voltage on the rating plate. Never
attempt to replace the charger
unit with a regular mains plug.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Features
This appliance includes some or all of the following features.
1. Charger
2. Charging indicator
Assembly
Warning! Before assembly, remove the battery from the
appliance/tool.
Fitting and removing the battery
To fit the battery, line it up with the receptacle on the tool.
u
Slide the battery into the receptacle and push until the
battery snaps into place.
To remove the battery, push the battery release button
u
while at the same time pulling the battery out of the
receptacle.
Use
Warning! Let the tool work at its own pace. Do not overload.
Charging the battery
The battery needs to be charged before first use and
whenever it fails to produce sufficient power on jobs that were
easily done before. The battery may become warm while
charging; this is normal and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging
temperature: approx. 24 °C.
Note: The charger will not charge a battery if the cell
temperature is below approximately 10°C or above 40 °C.
The battery should be left in the charger and the
charger will begin to charge automatically when the cell
temperature warms up or cools down.
To charge the battery, insert it into the charger (1). The
u
battery will only fit into the charger in one way. Do not
force. Be sure that the battery is fully seated in the
charger.
Plug in the charger and switch on at the mains.
u
The charging indicator (2) will blink.
The charge is complete when the charging indicator (2)
switches to continuously on. The charger and the battery can
be left connected indefinitely.
The LED will switch on as the charger occasionally
tops up the battery charge.