Recommendations For Installation; General Notes - Diamond GF-1C Manual De Montaje

1. Reception
On receiving the equipment, check carefully that the packaging is intact and has not been damaged in transit.
After unpacking, check that you have all the components and if the characteristics correspond to those on the order
form.
Installation, maintenance and other work should be carried out by specialised and authorised technicians. The
manufacturer accepts no responsibility and will not cover the guarantee if these conditions are not respected.
This appliance must be used according to these instructions and only for the manufacturer's purpose. The incorrect use of the
equipment can cause damages to the equipment and to users.
As a result of our constant effort to make technological improvements, the specifications indicated here are subject to change
without warning.
2 – Identification
Our models have a plate behind the control panel on which the main data can be found. The MODEL and SERIES / YEAR are
absolutely essential when consulting the manufacturer.
Legend:
1
2
3
4
5
6
The crossed-out wheeled bin means that within the European Union the product must be taken to separate
collection at the product end-of life. This applies to your device but also to any enhancements marked with
this symbol. Do not dispose of these products as an unsorted municipal waste.
3 – Recommendations for Installation
3.1 – General Notes
Although the production of each appliance is rigorously controlled during manufacture, this does not exclude the possibility of
damage caused in transit. The general condition of the appliance should therefore be checked on arrival.
3.2 - Placing
Remove the packaging or pallet carefully so that the equipment's surfaces are not damaged. Remove the PVC
•
protection.
The appliance should be installed away from heat sources (ex: heating appliances) and direct sunlight.
•
To ensure that the appliance functions well, it should always be correctly levelled and slightly inclined to the back, to make sure
•
that the doors close perfectly. Small differences in level can be compensated for by regulating the feet.
3.3 - Installation
The following standards should always be bared in mind during installation:
Regulations concerning the buildings, and anti-fire standards.
•
Rules concerning accident prevention.
•
European standards into effect.
•
MNS00011.01
TEC
Assembly Instructions
MODEL
CODE
SERIAL N.º/YEAR
CURRENT
VOLTAGE/FREQ.
POWER
- Model
- Code
- Series Number / Year
- Doesn't apply
- Doesn't apply
- Doesn't apply
DOOR RESISTANCE
LIGHT POWER (MAX.)
DEFROST
COOLANT/QTY
TEMPERATURE CLASS
7 - Doesn't apply
8 - Doesn't apply
9 - Doesn't apply
10 - Doesn't apply
11 - Doesn't apply
12 - Doesn't apply
N.º
MNS00011.01
14/14