Safety And Installation Instructions - Dometic GROUP WAECO WPS900F Manual Del Usuario

Safety and installation instructions

1 Safety and installation instructions
The following texts are only a supplement to the illustrations featured
on the supplementary sheet. They do not contain the full installation
and operating instructions. Please observe the illustrations on the sup-
plementary sheet.
Please observe the prescribed safety instructions and stipulations
from the vehicle manufacturer and service workshops.
The manufacturer accepts no liability for damage in the following cases:
 Damage to the product resulting from mechanical influences and excess
voltage
 Alterations to the product without express permission from the manu-
facturer
 Use for purposes other than those described in the operating manual
 Installing the parking aid can cause problems on vehicles with
A
LED tail lights.
 On vehicles with a spare tyre fitted to the outside of the vehicle,
or a tow bar attached to the outside, please observe the setting
parameters in chapter "Setting the system" on page 36.
 If you would like to install the sensors on metal bumpers, you will
require suitable adapters (not included in the scope of delivery).
 Observe the applicable legal regulations.
 Secure the parts of the parking aid which are installed in the
vehicle in such a way that they cannot become loose under any
circumstances (sudden braking, accidents) and cause injuries
to the occupants of the vehicle.
 Do not install the parts of the parking aid anywhere in the vehicle
where an airbag may open. This could cause injury if the airbag
deploys.
 The sensors may not cover signal lamps.
 When fitting the sensors, make sure there are no objects fixed
to the front of the vehicle and no large objects mounted near the
tailgate (such as a bicycle rack) which are in the detection range
of the sensors.
26
WPS900F/WPS910
EN