Electrolux EFUP193YSK Manual De Instrucciones página 19

35 electrolux installation
Do not substitute the original
refrigerator legs.
Wait at least 2 hours before plugging
the refrigerator in this will prevent
operating problems.
Electrical installation
Before turning on the freezer, check to
see if the voltage of the outlet to be
used is the same as that indicated on
the tag located close to the plug
(along the power cord) or on the
freezer's identification label.
Check to see that the freezer's plug is
not connected on top of the power
cord.
Connect the freezer to its own outlet.
Do not use an extension cord or
adaptor plug.
For your safety, ask an electrician to
verify the condition of the electric
wiring in the area where the freezer will
be installed. The wires leading to the
outlet into which the freezer will be
plugged should be made of copper
and be at least 2.5 mm2 wide. For
greater safety, consult the legislation
on electrical installations in your
country.
Grounding
The power cord has a three-pronged
grounded plug for your personal
safety. It must be connected to a
grounding type wall receptacle, in
accordance with the legislation
governing electric installations in your
country, as well as any local
regulations.
Do not remove the grounding prong,
do not use a two pronged adaptor,
and never make a connection to the
schematic.
Use the cord supplied with the
equipment (do not change it). If the
cord is damaged, it must be
immediately replaced by specialized
personnel.
It is very important for your freezer to be level in order to assure proper
operation. If the freezer is not leveled during installation, the lid may be
misaligned and it may not seal properly, causing cooling, frost, or moisture
problems.
Avoid fire or electric shock hazards. Do not use extension cords or adapter
plugs. Do not remove any prong from the power cord.
installation electrolux 36
For your safety, installation must be
grounded. If it is not grounded, it
must be adapted for this by
specialized personnel.