Charging Procedure; Charging Indicator - Ratio PRO XF20-D Manual De Instrucciones

of time, charge the battery every 3 months.
F1
green
light
F2

CHARGING PROCEDURE

1) Plug the charger into an appropriate outlet.
The light will be green.
2) Slide the battery pack into the charger, make
sure the battery is in the correct charge
position firmly. The light will turn to red to
indicate the charging process has started.
3) When charging is completed, the light will turn
to green.
4) After fully charged, unplug the charger and
remove the battery pack.
NOTE: If the battery pack is locked in the charger,
press the battery pack release button and remove
it.
WARNING: When battery charge runs
out after continuously use or exposure
to direct sunlight or heat, allow time for
the tool to cool down before re-charging to
achieve the full charge.

CHARGING INDICATOR

This charger is designed to detect some problems
that can arise with battery packs. Indicator
lights indicate problems (see table below). If this
occurs, insert a new battery pack to determine
if the charger is OK. If the new battery charges
correctly, then the original pack is defective and
should be returned to a service center or recycling
service center.
If the new battery pack displays the same problem
40
red
light
as the original Battery Pack, have the charger
tested at an authorized service center.
Light ON/OFF flash
Red on
Red flash
Green on
Green flash
NOTE: The battery chargers and the battery
packs illustrated or described above are not
included in the delivery.
OPERATION
1. OPERATING THE ON/OFF SWITCH (SEE
FIG. G)
To start the sander, press the on/off switch at the
position marked "I".
To stop the sander, depress the on/off switch at
the position marked "O".
G
2. USING THE SANDER (SEE FIG. H)
The workpiece to be sanded must be secured. If it
is small or it may move during sanding, it must be
held in a vice or suitably clamped.
Be sure to hold the sander firmly whilst it is turned
on and apply it gently to the work, it may "kick"
on first contact. Hold the sander so that it is flat
on the work and move slowly, preferably with
a smooth, circular motion. Regularly check the
condition of the sanding paper and replace when
worn for best results.
Status
Charging
Defective
- - - -
Battery
Fully Charged
Hot/Cold
- - - -
Delay