Publicidad
Idiomas disponibles
Idiomas disponibles
1
• Gather the three large curved base tubes and
the three uprights.
2
• Hold an upright so the wider
end is at the bottom. Attach one
end of the base tube to the
bottom of the upright. Note the
grooves only allow them to
attach in one direction and
some force may be required to
insert them ush with the base
of the upright. Repeat until the
circular base is formed.
3
• Find the larger loops on the top of
the net. Set the net aside. NOTE:
For preparation of Net Assembly
in Step 4, see Diagram A
4
• Attach one end of a small rim tube to the top of
an upright. Assembly is similar to Step 2. Slip four
of the large net loops over this section of the rim.
Now connect the other end of rim tube to the
next upright. Repeat until the circular rim is
formed with the net in place.
5
• Attach the three oat balls to the
attened sections of the base tubes.
Make sure that each ball's drain hole is
on the bottom.
6
• In ate basketball to approximately 5"
in diameter. Enjoy.
Thread Net on PVC Hoop.
This is the net right out of the package.
1
You will be working with the longer looped end.
2
This is a close-up of the circled portion on diagram 1.
This is one loop.
Fold the loop toward you, creating two loops.
3
Insert your nger through the two loops.
4
Release the thumb holding the loop in place and pull
5
on the two middle strings. The loop should slide up
and catch your ngers.
Take the loop from your nger and slide onto the
6
basketball hoop. Continue this process with each
loop until all loops are on the hoop.
Visit www.poolmaster.com for video of net installation
Diagram A
1
4
poolmaster.com
2
3
5
6
2
Publicidad
