Publicidad
Step 12
Separate the NARROW EXTENSION SLIDES (FF) from the NARROW EXTENSION RAILS (EE) as shown in the upper
å
diagram below. Be prepared, the parts are greasy.
Fasten four NARROW EXTENSION RAILS (EE) to the LEFT END (B) and UPRIGHT (E). Use eight GOLD 5/16" FLAT HEAD
å
SCREWS (3S) through holes #1 and #3.
NOTE: For each NARROW EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the
å
inner cartridge of the NARROW EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the ENDS and
UPRIGHTS. Turn a SCREW into this hole.
NOTE: The NARROW EXTENSION SLIDES will be used later for the SMALL DRAWERS.
å
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
EE
1
Open end
www.sauder.com/services
FF
Push the black lever in and pull the SLIDE from the RAIL.
3S
4
3
4
3
2
EE
2
1
B
EE
1
EE
2
EE
3
2
4
3
4
E
419956
Open end
1
4
3
Page 17
Publicidad
