Oster 76105 Manual De Instrucciones página 4

• Turn the clipper off when finished using.
• Cover the blades with the provided blade guard to protect the blades.
• Insert clipper into charging stand or plug into the auxiliary power cord.
(See section titled "CHARGING THE UNIT".)
• This unit is equipped with Ni-MH batteries. It's possible that after
continued use, you may encounter decreased battery life. If this happens,
discharge the unit completely by leaving it on until the unit
stops operating and the battery has been completely drained.
Do not leave unit unattended. Then follow the directions for
first time charging.
• This unit comes with a battery life indicator display. Once the
battery has reached less than 10 minutes of running time
left on the battery life the LED will turn to solid red and a low
battery life icon will appear on the display.
CORDED OPERATION
The clipper has been designed to use the auxiliary power cord if the battery is
low and the unit will not turn on as a result. If the battery is low and the unit has
stopped working or you notice that the power has decreased,
then you may still operate the unit by plugging in one end of
the power cord into the unit and the other end into an approved
wall outlet.
• Turn the unit OFF by moving the switch to the OFF position.
• Plug the power cord into an outlet with the rated voltage
for your unit.
• Plug the other end into the clipper. Note that the cord will
only fit into the
clipper with the proper orientation.
• Ensure that the switch on the unit is in the "Off" position.
• Turn the clipper ON using the "On-Off" switch and use the clipper. If the
clipper does not turn on, then the battery may be fully depleted and may
have to be partially charged prior to re-use. Follow the charging
procedure and let the battery charge for approximately 20 minutes.
• Turn the unit off when finished using.
• Cover the blades with the provided blade guard to protect the blades.
• Insert clipper into charging stand or plug into the power cord.
(See section titled "CHARGING THE UNIT".)
6
BLADE ADJUSTMENT AND BLADE REPLACEMENT
This unit is equipped with a slide blade adjustment mechanism. Please refer to
the blade size chart for hair length for each setting.
• Move the control button down to increase the length of hair left on the scalp.
• Move the control button up to decrease the length of hair left on the scalp.
• To remove or replace the blade, make sure the power switch is in the off
position. Unplug the unit from the accessory cord if in use. Turn the blade
adjustment all the way down to the 2.5mm setting. Then pull down on the
blade while holding the unit securely.
• To replace the blade, align the tab on the blade set with the tab receptacle
on the clipper and push the blade in.
SETTING
Blade
Sizes
BLADE COMB ATTACHMENTS
Your unit comes with several blade comb attachments. These are provided to
increase the functionality and enjoyment of your unit. The size of the comb is
located on the bottom of the comb attachment. To achieve the correct lengths
for each comb attachment set adjust the length of the blade to the smallest
cutting length.
(2.5mm) (1.9mm) (1.2mm) (.5mm)
1 .5 0A 000
7