Replacing The Battery - Wagan 2641 Manual De Usuario

3W Brite-Nite Spotlight Lantern by Wagan Tech
™
5. A full charge will provide up to 3–4 hours of spotlight use, or up to 12
hours of lantern use.
6. Let the lens cool for at least 30 minutes after use before storing.
7. Periodically wipe the entire spotlight with a soft clean cloth.
8. Caution: Do not store in direct sunlight or near a heat source. Do not
charge or store near open flames or sparks.
WARNINGS
• Wear ANSI-approved safety glasses when removing, installing or
otherwise contacting the battery.
• Inspect the spotlight before each use. Do not use if damaged or leaking
battery acid.
• Never point the light beam directly into the eyes of another person or
animal.
• This product is not a toy: Do not allow children to play with or near this
item.
• Use for intended purposes only.

REPLACING THE BATTERY

1. Turn the light off and disconnect any chargers.
2. Unscrew the 2 hex screws holding the back of the light in place and
remove the back.
3. Pull out the old battery. Disconnect the Positive (+) and Negative (−)
leads.
4
R
User's Manual—Read before using this equipment
4. Attach the leads on the replacement battery to the respective Positive
and Negative leads and place the battery into position within the light
housing.
5. Replace the back of the light and screw the 2 hex screws back in.
SPECIFICATIONS
Lead-Acid Battery (Replaceable)
Charging Indicator
Running Time (Spotlight Mode)
Running Time (Lantern Mode)
Charging Time
Bulb Type (Spotlight)
DC/DC Adapter (Cigarette Lighter Adapter)
Light Output (Spotlight)
©2009–2011 Wagan Corporation. All Rights Reserved.
Wagan and wagan.com are trademarks used by Wagan Corporation.
Battery
Hex Screws
Back Cover
Positive and
Negative Leads
Rechargeable 4 volt 2.8 Amp-Hour
Red LED
3–4 hours approximately
12 hours approximately
7–8 hours (AC), 8–10 hours (DC)
Bright White LED
12V DC, Fuse: 2 amp, 250 volt
2632 Lux
5