Operation; Care And Cleaning - Schön 67065-0101 Guía De Uso Y Cuidado

Installation (continued)
7
Remove the quick connector
□
If it is necessary to remove the quick connector
(1), squeeze the tabs (2) on the quick connector
and then pull down to disconnect.

Operation

1
Flushing and checking for leaks
IMPORTANT: After installation is completed, turn on the
hot and cold water supplies. Check for leaks.
□
Pull the hose assembly out of the spout and
remove the spray head by unscrewing it from
the hose in a counterclockwise direction. Be
sure to hold the end of the hose down into the
sink and turn the faucet on to the warm position
where it mixes hot and cold water.
□
Flush the water lines for one minute. This ushes
away any debris that could cause damage to
internal parts. Check for leaks.
□
Re-tighten any connections if necessary, but do
not overtighten. Reinstall the spray head by hand
tightening it back onto the spray hose.

Care and Cleaning

□
□
□
Do not use abrasive cleaners when cleaning this faucet.
Squeeze
1
7
Please contact (800) 880-8164 for further assistance.
2
Pull
down
1
www.schonsimplymodern.com