Heat Surge Flame Manual De Instrucciones página 3

DO NOT modify this heating unit. Use it only as described in this manual. any other use not recommended by the
manufacturer may cause fire, electrical shock or injury.
The output air may vary in temperature. at times the air may become intense enough to burn exposed skin. Use
of this heating unit is not recommended for persons with reduced sensitivity to heat or an inability to react to
avoid burns.
DO NOT burn wood or other materials in this fireplace.
DO NOT strike fireplace glass.
when transporting or storing the fireplace and cord, keep in a dry place, free from excessive vibration and store so
as to avoid damage.
This heater has a self‑protection function. if the heater does not operate normally, to reset the heater, unplug the
power cord from outlet for 15 minutes. Then plug the power cord back in for reuse of the heater.
SAVE ThESE INSTRUCTIONS.
SET UP
Place the heating unit on a firm, level surface free of obstructions and at least 3 ft. (0.9 m) away from any combustible
materials. DO NOT use on an unstable surface such as bedding or deep carpeting.
OPERATION
This Section will explain the function of each convenient control.
INSTRUCTIONS
CAUTION: TO PREVENT ELECTRIC ShOCK, mATCh WIDE bLADE Of
PLUG TO WIDE SLOT. fULLy INSERT.
CONSUmER SAfETy INfORmATION
THIS APPLIANCE HAS A POLARIZED PLUG
reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. if
the plug does not fit fully in the outlet, reverse the plug. if it still does not fit, contact a qualified
electrician to install the proper outlet.
DO NOT ATTEmPT TO mODIfy ThIS PLUG OR DEfEAT ThIS SAfETy
fEATURE IN ANy WAy.
The heater may emit a slight, harmless odor when first used. This odor is a normal condition
caused by initial heating of internal heater parts and will not occur again.
fIREPLACE CONTROL PANEL
The fireplace control panel is located on the back upper right hand corner of the unit.
To locate controls refer to FiGUre 1
a – Main/POwer On/OFF SwiTCH: The fireplace on/off switch supplies the main power to the
fireplace as well as brightening the flame and embers of the fireplace.
B – HeaTer On/OFF SwiTCH: The heater switch is used to turn the heater on or off. The heat
function is operational only when the main/power switch is in the "on" position.
(one blade is wider than the other). To
(FiGUre 1)
2