Control Panel And Features - Kenmore 110.22352510 Manual De Uso Y Cuidado

1
1
SOIL LEVEL
Select the setting most suitable for your load. For heavily
soiled and sturdy fabrics, select Heavy Soil Level for more
wash time. For lightly soiled and delicate fabrics, select Light
Soil Level for less wash time. A lighter soil-level setting will
help reduce tangling and wrinkling.
2
WASH TEMP
Wash Temp senses and maintains uniform water temperatures
by regulating incoming hot and cold water.
Select a wash temperature based on the type of fabric and
soils being washed. For best results and following the garment
label instructions, use the warmest wash water safe for
your fabric.
• On some models and cycles, warm and hot water may be
cooler than your previous washer.
• Even in a cold and cool water wash, some warm water
may be added to the washer to maintain a minimum
temperature.
All rinses are cold.
3
WASH CYCLE KNOB
Use the Wash Cycle knob to select cycles on your washer.
See "Cycle Guide" for detailed descriptions of cycles.
4
WATER LEVEL
Set the Water Level knob to the Auto setting and the washer
will automatically sense the appropriate water level for the
load size and type.
Set the Water Level knob to the Deep Fill setting and the
washer will fill to the maximum water level.
NOTE: Expect longer cycles times due to extended fill times
when using the Deep Fill option.
4

CONTROL PANEL AND FEATURES

2
Not all features and options are available on all models.
Appearance may vary.
3
7 6
5
RINSE OPTIONS
The following options may be added to most cycles. See
"Cycle Guide" for additional details.
ONE RINSE
This option is used to limit a cycle to one rinse.
TWO RINSES
This option can be used to automatically add a second
rinse to most cycles.
ONE RINSE WITH FABRIC SOFTENER
This option must be selected if using fabric softener during
a cycle. It ensures that fabric softener is added
at the correct time in the rinse for even distribution.
TWO RINSES WITH FABRIC SOFTENER
This option turns on both the Fabric Softener and the
Two Rinses option.
6
START/PAUSE/Unlock Lid BUTTON
Press to start the selected cycle; press again to pause the
cycle and unlock the lid.
NOTE: If the washer is spinning, it may take several minutes to
unlock the lid. Press and hold for 3 seconds to cancel a cycle.
7 CYCLE STATUS LIGHTS
The Cycle Status Lights show the progress of a cycle. At each
stage of the process, you may notice sounds or pauses that
are different from your previous washer.
SENSING
When the Start/Pause/Unlock Lid button is pressed, and
the Water Level knob is set to Auto, the washer will fill and
begin sensing to determine load size and balance.
Once sensing is complete, the washer will fill to the
appropriate level for the detected load size and then
begin the wash phase of the cycle.
NOTE: Sensing and wash phases will be paused by
opening the unlocked lid. Close the lid to resume the cycle.
If the lid is left open for more than 10 minutes, the washer
will cancel the cycle and pump out the water. The lid will
lock after the wash phase to begin the initial spinout and
remain locked for the remainder of the cycle.
4 5