Publicidad
Step 11
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (I) to the LEFT END (B). Use the screws
å
in the HINGES. See the next step for adjustments.
Peel one of the CORK BUMPERS from the CORK PAD (X).
å
Stick the BUMPER on the DOOR where it comes in contact
with the LEFT UPRIGHT (D).
Fasten a PULL (Y) to the DOOR (I). Use a BLACK 1-1/8"
å
MACHINE SCREW (CC).
Repeat this step for the other DOOR (I).
å
NOTE: Insert the PULL post into the top hole of the left
å
DOOR and the bottom hole of the right DOOR.
Post
Y
X
www.sauder.com/services
B
I
CC
BLACK 1-1/8" MACHINE SCREW
(2 used in this step)
D
407432
Stop
Mounting
screw
Page 15
Publicidad
