Cleaning The Heater - Melchioni Family THERMAL D Manual De Usuario

CONVECTOR HEATER WITH THERMOSTAT – Model A
Choose a suitable location for the heater, taking into account the safety instructions above. Insert the plug of the
heater into a suitable socket. Turn the thermostat knob fully in a clockwise direction to the maximum setting.
Turn on the heating elements by means of the rocker switches on the side panel. When the heating elements are on
the switches will illuminate. For maximum heat output both switches should be on.
When the desired room temperature has been reached, the thermostat knob should be turned slowly anti-clockwise
until the thermostat is heard to click off and the lights on the element switches are seen to go out. After this the
heater will keep the air temperature in the room at the set temperature by switching on and off automatically.
CONVECTOR HEATER WITH THERMOSTAT AND FAN – Model B
All the above instructions for model A (above) also apply to model B.
Model B also incorporates an internal fan, which can be switched on independently of the heating elements.
Fan Operation: -This is operated by means of the switch with the fan symbol along side it. The fan will only operate
with the thermostat in the "on" position and can be used when the heating elements are "on" to blow warm air into
the room. In warm conditions the fan can be used with the heating elements "off" to blow cool air into the room.
CONVECTOR HEATER WITH THERMOSTAT AND TIMER – Model C
All the above instructions for model A (above) also apply to model D.
This model is also fitted with a 24hr timer which has 96 segments around its circumference, each segment being
equivalent to 15 minutes of time. With the aid of this timer it is possible to preset the time and duration of the
period(s) that it is desired the heater will operate, in any 24hr period.
Timer Operation
The centre of the timer has a 3 position slide switch. In the central position (denoted by the clock symbol) the timer
will switch the heater on and off at times set by the segments, (see setting the timer, below).
The position denoted by the "I", is a timer override position. The timer will continue to run but power will be fed
continuously to the heater. This enables the heater to be on all the time if required. In the position denoted by the
"O", the timer continues to run but no power is fed to the heater.
Setting the Timer
Ensure the slide switch on the timer is at the mid position next to the clock symbol.
Rotate the outer ring of the timer in a clockwise direction until the current time is lined up with the arrow pointer, i.e.
if the time the timer is being set is 8 p.m., rotate the outer ring until the number 20 is in line with the arrow pointer.
Set the time the heater is required to run by pulling the segments around the outer ring forward appropriate to the
running period(s) required.
When set, the heater will operate each day during the times programmed. Note, the heater must always be plugged
into a power socket, the element switches must be in the on position and the thermostat must be suitably set to
ensure the heater will come on.
If the heater is required to run continuously the slide switch on
the timer should be set to the "I" position.
If it is subsequently required to revert back to timer operation,
the slide switch on the timer should be set to the central (clock)
position.
Note: When using in timer mode, due consideration should be
given to the fact that the heater may come on whilst unattended.
CONVECTOR HEATER WITH THERMOSTAT, TIMER AND FAN – Model D
All the above instructions for models A and B (above) and C (above) also apply to model D.

CLEANING THE HEATER

Always un-plug the heater from the wall socket and allow it to cool down before cleaning. Clean the outside of the
heater by wiping with a damp cloth and buff with a dry cloth. Do not use any detergents or abrasives and do not allow