Qilive Q.6594 Manual De Instrucciones página 26

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 65
When to refill the rinse-aid
EN
How often you need to refill the rinse-aid dispenser depends on how often dishes are
washed and which rinse-aid setting is used.
The Low Rinse Aid indicator (
is needed.
Do not overfill the rinse-aid dispenser.
Function of detergent
The chemical ingredients that compose the detergent are necessary to remove, crush
and dispense all dirt out of the appliance. Most of the commercial quality detergents
are suitable for this purpose.
WARNING! Use only detergent specifically made for dishwashers use. Keep
your detergent fresh and dry.
Do not put powdered detergent into the dispenser until you are ready to wash
dishes.
Dishwasher detergent is corrosive! Keep dishwasher detergent out of the
reach of children.
Filling and adjusting the rinse aid reservoir
Fig. P)
(
1.
Remove the rinse reservoir cap by lifting the handle.
2.
Pour the rise aid into the dispenser, be careful not to overfill.
3.
Close the cap after refilling.
Adjusting the rinse-aid reservoir
To achieve better drying results, with limited rinse-aid, the dishwasher is designed to
allow you to adjust the rinse-aid consumption.
1.
Switch on the dishwasher.
2.
Within 60 seconds of step 1, press the Start/Pause button and hold for at least 5
seconds. To enter the set mode, press the Delay button. The Rinse Aid indicator
blinks at a 1Hz frequency.
3.
To select the setting that matches your needs and habits, press the Start/Pause
button. The sets change in the following sequence: D1->D2->D3->D4->D5->D1.
The higher the number, the greater the rinse-aid dispensed.
4.
To exit the set mode, wait 5 seconds or press the Start/Pause button. The new
setting take effect.
Filling the detergent dispenser
1.
Choose one of the following actions for opening the detergent dispenser,
depending on your actual appliance: (Fig. Q, left)
a. Open the cap by sliding the release catch to the right. (1)
b. Open the cap by pressing down on the release catch. (2)
2.
(Fig.Q, right) Add detergent to the larger cavity (A) for the main wash cycle. For
a better cleaning result, especially if you have very dirty dishware, pour a small
amount of dishwashing detergent into the door of the detergent dispenser. The
additional detergent activates during the pre-wash phase.
3.
Slide the door closed and then press it down.
Note:
Be aware that depending on the quality of the water, the setting may vary.
Observe the detergent manufacturer's recommendations for use.
) will appear in the display when more rinse-aid
26

Publicidad

Tabla de contenido
loading

Tabla de contenido