Hansgrohe 14870 Serie Manual De Instrucciones página 7

Important! The fitting must installed, flushed and
tested after the valid norms!
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the sink.
3. Slip the plastic washer, the slide washer, the
metall washer and collar nut over the hose and
threaded base and tighten the collar nut by
hand. If there is not enough space, please use
only the slide washer and the metall without the
plastic washer.
4. Tighten screws.
5. Connect the connecting hose / supply pipes to
the angle valves;
cold right ­ hot left.
Large differences in pressure between the hot and
cold water supply should be balanced.
Technical Data
Operating pressure:
Recommended operating pressure: 0.1 ­ 0.5 MPa
Test pressure:
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Rate of flow:
Hansgrohe single lever mixers can be used toge­
ther with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0.15 MPa.
To adjust the hot water limiter on single lever
mixers, please see page 17.
No adjustment is necessary when using a conti­
nuous flow water heater.
English
max. 1 MPa
1.6 MPa
max. 80° C
65° C
13 l/min 0.3 MPa
Spare parts (see page 4)
1 llever head
1.1 screw cover
2 flange
3 nut
4 cartridge cpl.
5 aerator cpl.
6 fixation cpl.
7 connection hose 900 mm
8 spout cpl. Allegra Cucina
9 sealing set
10 ELASTOP stop unit
XXX = Colors
000 chrome plated
750 alux
800 stainless steel optic
10490XXX
96338000
96468000
96461000
92730000
13913000
95049000
94082000
92830XXX
92646000
94849000