Detección Y Resolución De Problemas - Klarstein Powericer ECO 3 Manual De Instrucciones

DETECCIÓN Y RESOLUCIÓN DE PROBLEMAS
Si el agua no fluye de manera simétrica a través del evaporador, es posible que en el
conducto se formen pequeños sedimentos, causando una obstrucción en el evaporador.
En ese caso, retire el tapón del conducto y deje que el agua fluya para limpiarlo.
Problema
The compressor works
abnormally with a buzzing
noise.
The light of ADD WATER
is on.
Indicator light on the
display is not on.
The water is flowing,ice is
made,however no release
of ice.
Everything is correct but
no ice is made.
Spray pipe jammed.
Posible causa
The voltage is lower than
recommended.
There is no water or water
is not enough.
Control panel wire line is
loosen.
Control panel is broken.
Temperature sensors are
connected by mitake.
Refrigerant leaks.
Cooling system blocked.
Step 1: Take down the spray pipe from the evaporator.
Step 2: Take off the pipe plug from the spray pipe.
Step 3: Let water flow from the pipe for a while. Fix the
spray pipe from step 3 to step 1.
Solución
Stop the Ice maker and do
not restart until the voltage
is normal.
Press the "STOP" button,
fill with water, and press
the "START" button again
to restart.
Call for service.
Call for service.
Call for service.
ES
31