Publicidad
Idiomas disponibles
Idiomas disponibles
2.2
The battery
Before connecting the battery, check the battery's charge state by pressing the power button.
Four LEDs indicate the state (100%, 75%, 50%, 25%).
Important: The battery can deliver different output voltages.
Make sure the display shows 12VDC!
Changing the supply Voltage
Press and hold the power button for more than one second until the voltage indicator LEDs flash.
Another short touch of the power button changes the voltage. When 12VDC is reached, stop
switching and release the button. After approx. three seconds, the voltage selection is displayed
statically.
Connecting the Battery
When the battery is sufficiently charged, and the voltage selection LED shows 12VDC, connect the
Mobile SureStreamer to the battery. Inside the battery bag is the connection cable that you connect
to the output socket of the battery (blue arrow on image). Push the connector firmly.
The two sockets for the round plug have the same size. One is to connect the charger and the other is
the power output. Due to the arrangement of the cables, a mix-up is unlikely. Should there be an
accidental mix-up, there will be no damage. The two round sockets are electrically protected against
damage.
Connect the device to the power outlet (blue arrow).
The USB ports can be used for charging a phone or other accessories.
Figure 4: Battery pack in the bag and zoom on the connectors
To configure your Mobile SureStreamer, please download and read the Configuration guide:
https://www.worldcastsystems.com/catalog/documentation/documents/quick-start-
guides/mobile_surestreamer_quickstart_en.pdf
USB
Power
DC In
5V Out
button
English version
DC Out
5
Publicidad
