Baby Jogger city sway Instrucciones Para El Ensamblaje página 13

ASSEMBLING THE SEAT
EN
1 Remove the product from the
box and place upright on the
frame.
2 Press the button on the back of
the seat to raise the seat from
the storage position.
INSTALLING TOY BAR
3 Slide the toy bar attachment onto
the frame.
4 Rotate the toybar into one of the
raised positions.
NOTE: Toys may differ between
products.
USING AS BOUNCER
5 To use as a bouncer, rotate
kickstand down. Put into one of
the three recline positions.
USING AS ROCKER
6 To use as a rocker, rotate
kickstand up. Put into one of the
three recline positions.
RECLINING SEAT
7 Press the recline button on the
back of the seat to raise the
seat to one of the three recline
positions.
RAISING AND LOWERING LEG
SUPPORT
8 To lift leg support, pull up on the
leg support.
9 To lower leg support, push
buttons on the base of the leg
support. Push the leg support
down.
SECURING CHILD
10 Insert side strap buckle into
harness buckle on both sides.
11 Insert connected harness and
side strap buckles into the sides
of the crotch buckle.
12 Press button on crotch buckle to
release.
ADJUSTING HARNESS
13 To tighten harness pinch the
crotch buckle. Pull the front strap
below the clip to tighten strap.
14 To loosen the harness, pinch the
crotch buckle and hold the strap
above the clip and pull down.
USING VIBRATION UNIT
15 Open the battery compartment
lid on the underside of the seat
by inserting a flathead in the slot.
Insert two 3AA (LR06) batteries
(not included).
Replace lid.
16 The vibration unit is located
under the flap on the leg support.
17 Hold the button down to turn on
the vibration unit.
18 Press the button to alternate
between the high and low
vibration settings.
19 Hold the vibration button down
to turn unit off.
NOTE: The vibration unit will
automatically shut off after an
hour of use.
STORING PRODUCT
20 To lower the seat, press the
recline button at the top of the
seat while pressing the fold
button on the underside of the
foot of the frame.
21 Lower the seat to the lowest
setting for storage mode.
REMOVING INFANT BODY
SUPPORT
22 Unclip the harness.
23 Push shoulder harness through
the infant body support.
24 Push the waist clips through the
infant body support.
25 Slide the buckle cover off of the
crotch buckle.
26 Push crotch buckle through the
infant body support.
13