How To Operate - Nostalgia Vintage Collection CCP900 Instrucciones Y Recetas

HOW TO OPERATE

Before first use, clean the inside of the unit by wiping with a moist, non-abrasive
sponge, towel or cloth and then wipe with a non-abrasive dry towel. Wipe down the
inside of the Kettle and be sure it is properly placed in the brackets before starting.
Crank Handle
1. First, find a flat surface near an electrical outlet before starting. Make sure your cord
is away from any water source. It is acceptable to use an extension cord if needed.
2. Gather your popcorn making supplies: popcorn, seasonings, bowls or bags for
holding the popcorn, cooking oil, Kernel Measuring Cup and Oil Measuring Spoon.
(Kernel Measuring Cup and Oil Measuring Spoon are included with your unit).
3. Make sure Kettle is properly secured in support brackets.
4. Make sure Kettle motor is fully plugged into the outlet located on the bottom
side of the kettle. NOTE: Kettle will not heat if plug is not fully inserted.
5. Plug in the appliance while switch is flipped to OFF position.
6. Turn appliance ON by flipping the switch on the top of the machine (see illustration above
for location of switches). Allow the appliance to run 3-5 minutes to heat up Kettle.
7. Once Kettle has heated, turn unit OFF before adding ingredients.
8. Use the Oil Measuring Spoon supplied with your 1890s ANTIQUE POPCORN
CART to add 3 tablepoons of your favorite popcorn cooking oil to the
Kettle. For every Measuring Cup full of kernels (6 oz.), add 3 spoonfuls (3
tbsp.) of oil. For best results, light vegetable oil is recommended.
9. Add 6 oz. popcorn kernels to the Kettle using supplied Kernel Measuring Cup.
10. Close the door and turn unit ON. Turning the light switch to the ON
position to turn on the light and activate the warmer.
11. In no time at all, you will hear the popping begin. Fresh, hot popcorn will
begin to burst out of the flip lids on the Kettle - just like at the theater!
9
ON / OFF & Light
Switches
Stainless Steel
Kettle