Hoover F3860/1-011 Manual Del Usuario página 5

GB
ACCESSORIES
Polishers are equipped with spring loaded brushes and pads in order to obtain the best results
even on floors with uneven surface.
For this reason, the small narrow brush positioned on the front of the hood is also spring loaded.
Three kits of brushes and pads are supplied with the polisher:
Yellow Hard Bristle Brushes*
To be used to remove the old polish then to spread the new wax evenly on the floor. Particularly
suitable for marble and tiles.
Black Soft Bristle Brushes*
Must be used to complete the first polishing phase. Suitable for all hard floors.
Grey Buffing Pads*
To be used during the final polishing phase for producing a high gloss.
They can be used on all hard surfaces, but are especially suitable for marble and tiles.
Natural White Pads*
These natural white pads, made mainly of wool, have been especially designed to polish wooden
floors. They should be used after the Black soft brushes.
TO WAX AND POLISH THE FLOORS
TO WAX THE FLOORS:
Before applying polish, ensure that the surface is clean. Remove any greasy stains using a damp
cloth.
To apply the polish, follow the instructions supplied with the polish.
Use a good quality polish, spreading it evenly. After the polish has dried, polish the floor with the
yellow hard texture brushes or the softer black brushes.
TO POLISH THE FLOORS:
For producing a high gloss, use the natural white pads for wooden floors or grey buffing pads for
all other hard surfaces.
To obtain better results, always move the polisher in straight lines rather than in circles.
Buffing pads should only be used after the whole surface has first been polished with brushes.
EMPTYING OUTER BAG / PAPER DUST BAG
The suction polisher collects dust in the bag. To maintain the efficiency of your polisher check the
dust level and empty the cloth bag or replace the paper dust bag frequently.
MODELS EQUIPPED WITH PAPER DUST BAG:
Fully open zip fastener and remove paper dust bag by pulling the cardboard collar from the air
duct. (Fig. 5)
Fit new paper dust bag as described in paragraph "Fitting the paper dust bag".
MODELS EQUIPPED WITH CLOTH BAG (WITHOUT PAPER DUST BAG):
Remove the cloth bag from upper plastic clip (Fig. 7) and disconnect bottom plastic flange from
hood pressing lightly on the indent on the flange.
Turn cloth bag upside down and shake gently. (Fig. 8)
The cloth bag can be washed. We suggest hand washing it in warm water with a mild detergent.
CLEANING BRUSHES AND PADS
Brushes may be washed in warm water with a mild detergent.
Pads may be gently brushed with soapy water and wiped with a damp cloth. Do not immerse the
pads in the soapy water.
Allow the pads to dry thoroughly before use, keeping them flat.
* Certain Models Only
5