Technical Specifications - Harman Kardon GO+PLAY WIRELESS El Manual Del Propietario

HARMAN KARDON
GO + PLAY WIRELESS
Listening to Audio from a Bluetooth-Capable Device
1. Press the Harman Kardon Go + Play Wireless's "Power" button. The Status LED will illuminate white.
2. The Harman Kardon Go + Play Wireless unit will automatically enter the Bluetooth pairing mode.
3. Perform a new device search on your Bluetooth-capable device.
4. Select "GO+PLAY WIRELESS" on the device's pairing list. If the device asks for a passcode,
enter 0000.
5. When pairing is successful the Harman Kardon Go + Play Wireless's Status LED will change
to blue.
6. Control playback from your Bluetooth-capable device.
To pair with a different device, press and hold the Power button until the LED turns white, then
repeat steps 3 – 5 above.
Listening to Music from an Auxiliary Device
1. Connect the auxiliary device's output into the "Aux in" jack by using a stereo 3.5mm (1/8"
auxiliary cable (not supplied).
2. Press the "Power" button located on top of the Harman Kardon Go + Play Wireless system
to turn on the unit.
3. Control music playback through the auxiliary device.
4. Adjust volume using the Volume Up ("+") and Volume Down ("–") buttons located on top of
the unit.
Charging Your iPhone/iPod
1. Use the cable that came with your iPad, iPhone or iPod to connect it to the rear USB port
of the Go+Play Wireless. (The rubber landing area on top of your Go+Play Wireless is the
perfect place for resting your iPhone or iPod while charging.)
2. Make sure that the Harman Kardon Go + Play Wireless unit is connected to a live electrical
outlet. Note: The Harman Kardon Go + Play Wireless system will not charge other devices.
3. The Harman Kardon Go + Play Wireless unit will not charge an iPhone/iPod device while
running on battery power.

Technical Specifications

Model:
Optional batteries for unit:
Drivers:
Power:
Frequency response:
Input sensitivity (Aux In):
Bluetooth transmitter frequency range:
Bluetooth transmitter power:
Bluetooth transmitter modulation:
Dimensions:
Weight:
Input impedance:
Signal-to-noise ratio:
External power supply
Power consumption:
HARMAN International hereby declares that this equipment is in compliance with the essential requirements
and other relevant provisions of Directive 1999/5/EC, ErP 2009/125/EC Directive and RoHS 2011/65/EU
Directive. The declaration of conformity may be consulted in the support section of our Web site, accessible
from www.harmankardon.com
4
Bluetooth Pairing and
Technical Specifications
Harman Kardon Go + Play Wireless
™
8 type D alkaline batteries
Two Ridge and two Atlas transducers
Tweeters: 2 x 15 watts @ 1% THD
Woofers: 2 x 30 watts @ 1% THD
40Hz – 20kHz
250mV
2.4GHz – 2.4835GHz
≤20dBm (EIRP)
GFSK/ /4-DQPSK/8-DPSK
Length: 20" (500mm)
Width: 9" (230mm)
Height: 9-1/2" (240mm)
9.4 lb (4.3kg)
>10k ohms
>85dB
Input voltage: 100 – 240V AC
Output voltage: 18VDC @ 3.6A
65W (maximum); 0.5W (standby mode)