Charging The Battery - Hilti ST 1800-A22 Manual De Instrucciones Original

5 Operation
5.1

Charging the battery

1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery.
5.2 Inserting the battery
WARNING
Risk of injury! Inadvertent starting of the impact screwdriver.
▶ Before fitting the battery, check that the cordless impact screwdriver is switched off and that the
forward/reverse switch is in the middle position (i.e. safety lock engaged).
WARNING
Electrical hazards! Risk of short circuiting.
▶ Before inserting the battery, check to ensure that the battery terminals and the contacts in the impact
screwdriver are free from foreign objects.
WARNING
Risk of injury! Hazard presented by a falling battery.
▶ A falling battery may present a risk of injury to yourself and others. Check that the battery is securely
seated in the power tool.
Make sure that the outer surfaces of the battery are clean and dry before inserting the battery in an
approved battery charger.
▶ Push the battery into the product from the rear as far as it will go and until it is heard to engage with a
double click.
5.3 Removing the battery
▶ Remove the battery.
5.4 Fitting / removing the depth gauge (optional)
When driving screws with a sealing washer, use a depth gauge suitable for the diameter of the sealing
washer (accessory). When the depth gauge is correctly adjusted the screw seal will be correctly
compressed.
The depth gauge is attached to the metal construction screwdriver by way of a snap-on connection
and can be simply pulled off or pushed on.
▶ Fit the depth gauge.
5.5 Using the protective cap
When the depth gauge is not fitted, the guard protects the depth gauge holder from dirt and damage.
▶ Use the protective cap.
5.6 Setting forward or reverse rotation
An interlock prevents switching while the motor is running.
The control switch is locked when the forward/reverse switch is in the middle position (safety lock).
18 English
Printed: 05.06.2019 | Doc-Nr: PUB / 5070730 / 000 / 07
2
3
5
6
4
439718
*439718*