Connecting To A Subwoofer/Lfe Output - monolith THX 24456 Manual Del Usuario

3. (Optional) Using another XLR cable, plug one end into the XLR BALANCED INPUT on
another Monolith™ subwoofer, then plug the other end into the XLR DIRECT PASS-
THRU jack on the subwoofer.
4. Plug one end of the included AC power cable into the FUSE/120 VAC connector on
the subwoofer, then plug the other end into a nearby AC power outlet.
Warning! Due to the power requirements of the Monolith™ subwoofer, do not
connect to the accessory outlets on a receiver or processor. If using a power strip,
ensure that it is rated to accommodate the subwoofer's power requirements.
5. Plug in and power on all connected equipment.
6. Set the POWER switch on the subwoofer to the AUTO ON/OFF or ALWAYS ON
position, as desired.
7. Using the information in the
desired starting positions, then adjust as needed.

Connecting to a Subwoofer/LFE Output

If your amplifier has a Subwoofer or LFE output, you can connect to the subwoofer using a
single, mono RCA cable. Perform the following steps to connect the subwoofer to a
dedicated subwoofer or LFE output on your receiver or amplifier. Note that any receiver
that can decode Dolby Digital™ or DTS® soundtracks will have a dedicated subwoofer or
LFE output.
1. Power off and unplug all equipment to be connected.
2. Using a single, mono RCA cable, plug one end into one of the LFE & LINE
UNBALANCED INPUTS on the subwoofer, then plug the other end into the
dedicated subwoofer or LFE output on your receiver.
3. (Optional) Using an XLR cable, plug one end into the XLR BALANCED INPUT on
another Monolith™ subwoofer, then plug the other end into the XLR DIRECT PASS-
THRU jack on the subwoofer.
4. Plug one end of the included AC power cable into the FUSE/120 VAC connector on
the subwoofer, then plug the other end into a nearby AC power outlet.
PRODUCT OVERVIEW
12
section, set the controls to the